Product Description
The GrateFix is a simple method of securely fastening steel, aluminium and fiberglass grating to support steelwork.
Using only an Allen Key to install, grating can be secured without welding or drilling. The GrateFix is designed to be installed from above the grating by one person. No access below the grating is required resulting in a quick and simple installation.
The GrateFix consists of a stepped malleable iron bottom casting complete with screw and saddle clip bracket. All items are available galvanised or in grades 304 and 316 stainless steel.
Technical data
| Product code | Material / finish | Screw dia | To suit grating bar centres (mm) | To suit grating bar depths (mm) | Tightening torque (Nm) | Body width (mm) |
|---|---|---|---|---|---|---|
| GF1 G10 ASSY | Pressed top bracket: Mild steel to EN 10025 grade S275 Cast bottom bracket: Malleable iron to BS 1562: Grade EN-GJMB-300-06 Both finished in mechanical galv to ASM B695 |
M10 | 30 to 41 mm | 50 | 5 | 0.750 |
Installation instructions
Step 1
Lower the GrateFix through the open part of the grating, ensure the bracket is seated over the adjacent bearing bars.
Lower the GrateFix through the open part of the grating, ensure the bracket is seated over the adjacent bearing bars.
Step 2
Slide the GrateFix towards the supporting steelwork flange as far as it will go to ensure maximum clamping force.
Slide the GrateFix towards the supporting steelwork flange as far as it will go to ensure maximum clamping force.
Step 3
Tighten the screw and ensure that the lower casting rotates until one of the steps locates on the bearing bar.
Tighten the screw and ensure that the lower casting rotates until one of the steps locates on the bearing bar.
Additional Information
| For Use With | Clamp for Steel, Aluminum & Fiberglass Grating |
|---|
