0844 800 0165

Opening Hours

9 AM - 5 PM


Simplified Building Concepts - Kee Access®, Kee Lite®, Fixings:, Handrail

We offer Free Delivery on all orders over £50.

Home Tech Data

Technical Data Sheets

Download the following data sheets for dimensional and load information

Installation Instructions

Clamping Range

The clamping range of the BoxBolt® connector is the combined thickness of the steel being connected and the steelwork being connected to. Each diameter of the BoxBolt® connector has three overlapping lengths designed to accommodate a wide range of material thicknesses. If your clamping range exceeds those stated above, special lengths are available.

Hole Dimensions & Positioning

It is important that the correct hole size is drilled to accommodate the body of the BoxBolt® connector. Dimensions are shown in the table below. If a BoxBolt® connector is being used close to the edge of a section or in close proximity to another BoxBolt® connector, a minimum spacing is required to ensure that the wings are free to expand correctly.

boxbolt tech data

Installation Diagram

boxbolt installation

STEP 1: Align the holes in the bracket to be secured with the pre-drilled hole in the structural tube. Insert the BOXBOLT through both pieces of steel until the underside of the shoulder is flush with the outside of the steel.

boxbolt installation

STEP 2: Hold the hexagon shoulder of the BoxBolt with an open ended wrench. Use an impact wrench or ratchet to tighten the core bolt.

boxbolt installation

STEP 3: Remove the open ended wrench and check to ensure that the core bolt is tightened to the recommended torque.

Application Examples

boxbolt examples

boxbolt examples

boxbolt examples